BCS SD03 speed dome 66 Instrukcja Instalacji

Speed Dome 66 Installation Manual

Figure 2-2 You can use socket head cap screw to fix hanging bracket and external cover component. (Please install waterproof sealing cushion)

Figure 2-4 Then please follow Figure 2-5 to insert the power pin, video/control pin, alarm cable pin to the corresponding sockets in the outlet. Note

Please use your hand to hold the camera and then adjust the lock tab between the camera and the panel. 1— Captive screw and semi-circle groove. 2—

Cable Heating Strip Steel Safety Rope Figure 2-8 Please refer to Figure 2-9 to install bottom cover. Please line the two round grooves

Figure 2-10 Pull the power cable, video/control, alarm cable through the bottom central hole, waterproof grew and bracket central hole. Pleas

Bottom cover connection: Please refer to Figure 2-8. Camera installation: Please refer to Figure 2-7. Bottom cover installation: Please refer to Figur

2.4.2 Pole Bracket Installation Please refer to Figure 2-15 to install clamp and pole bracket. Pull the cable out of the pole accessories and then

17 Figure 2-17 2.5 Suspended Bracket Speed Dome Installation 2.5.1 Installation Requirement Suspended bracket speed dome installation is s

Without wire slot With wire slot Figure 2-19 Loosen the M4 bolt in the flanges side. Separate the connection flange and pole and then pull

Teflon tape M4 Screw Silica gel Figure 2-21 Please loosen the M4 bolt at the splicing sleeve of pole bottom (just a little will be O.K), t

2Table of Contents 1 INSTALLATION... 6 1.1 Installa

20Camera installation: Please refer to Figure 2-7. Bottom cover installation. Please refer to Figure 2-9.

3 Protocol, Baud Rate, Address setup Before you operate, you need to set protocol, baud rate and address. Otherwise you can not control the product!

22OFF OFF 9600bps ON OFF 4800bps OFF ON 2400bps ON ON 1200bps Please refer to the parity setup sheet for detailed information. 7 8 Parity OFF OFF

4 Cable Connection 4.1 RS485 and Power Cable Connection There are three cable groups: power cable, RS 485 and video cable. Draw out the cables from

Figure 4-3 Name Function AC24V 24V power port. Connect to the power cable. EARTH Ground port. AC24V 24V power port. Connect to power cable. Exten

25Name Function Alarm out：1-2 z Two alarm output channels. When there is an alarm from current channel, system activates relay or not. z Alarm ou

3Welcome Thank you for purchasing our speed dome! Please read the following safeguards and warnings carefully before you install or use the product!

4Important Safeguards and Warnings Safety Measures Qualified Engineer Needed z The installation engineer or maintenance engineer shall have corre

5Do not try to dismantle or modify the device z There is risk of personal injury or device damage resulting from opening the shell. z Please contac

61 INSTALLATION 1.1 Installation Preparation Basic Requirement z All installation and operation here should conform to your local electrical saf

z Embedded installation z In-ceiling installation z Bracket installation 1.2.2 Bracket Installation Mode The bracket installation consists of the

Figure 1-2 1.2.2.3 Pole Installation Pole installation is suitable for indoor and outdoor hard pole structure. See Figure 1-3. Please refer to chapte

2 SPEED DOME INSTALLATION 2.1 General Introduction Speed dome consists of the following components. See Figure 2-1. Speed Dome Cover Component Bod